"I've noticed the same issue. Ive always assumed it was some networking problem in my end.
Having to reseed or add an athlete or relay seems to make it more likely to happen in my experience."
RaceTab
Meet management made simple.
Jeremy's Discussions
RACETAB AND FINISHLYNX
19 Replies
The GET RESULTS button is gone from Racetab. My times would not go over to Racetab. The database paths were all pointing to the same place.I entered my fat time. Status Auto or Manual?What is the…Continue
Started this discussion. Last reply by A J LaPlant Apr 7, 2018.
Jeremy's Page
Latest Activity
InsiderJason Byrne replied to Jeremy's discussion RACETAB AND FINISHLYNX
"That's very strange. The beep is supposed to be an auditory signal that RaceTab has seen and imported new results--it does this for Lynx and chip integration. As you said you did, you would still have to click the "refresh" to see any…"
Tom Ahlberg replied to Jeremy's discussion RACETAB AND FINISHLYNX"I have had the same issue when I setup and tested. Have not had a chance to use it live. I agree, there is no rhyme or reason to the times showing up. I am in Minnesota and we have had almost clear tracks then 6" of snow and today's meet…"
Randy Mayes replied to Jeremy's discussion RACETAB AND FINISHLYNX"We ran our first meet yesterday with the two computer FinishLynx/Race Tab setup and this was our only pain point. We have Race Tab 4.25 (the current latest). We had the Source "Status" set to "Automatic" in Race Tab.…"
Jim Gerweck replied to Jeremy's discussion RACETAB AND FINISHLYNX"It should - sometimes you have to press the Refresh button"
Tom Ahlberg replied to Jeremy's discussion RACETAB AND FINISHLYNX"I hear the noise and then the times appear, Will it recognize the new files written after evaluating the race on another computer?"
InsiderJason Byrne replied to Jeremy's discussion RACETAB AND FINISHLYNX
"Automatic mode normally works. And you will hear it make a little sound whenever times are imported."
Tom Ahlberg replied to Jeremy's discussion RACETAB AND FINISHLYNX"If I right click on the Camera icon and get times, then click on the refresh button the times populate. I usually have a computer for capturing the race and another for evaluating the image. I am afraid if I set it to automatically get times the…"
Jim Gerweck replied to Jeremy's discussion RACETAB AND FINISHLYNX"It's the 2 intertwined circular arrows between the X and the pencil. I've also found that going to the next heat, then back will make the times appear.Refresh.png"
Tom Ahlberg replied to Jeremy's discussion RACETAB AND FINISHLYNX"I looked for the “refresh” button but didn’t see anything. I pretty much tried everything. The only way to get the times is to right click on the score link which is dangerous because if I left click score all entries show scr. I…"
InsiderJason Byrne replied to Jeremy's discussion RACETAB AND FINISHLYNX
"If you're already in the heat that gets loaded, I think you can just click the "refresh" button. It's an icon like you have on your web browser to reload those results"
Tom Ahlberg replied to Jeremy's discussion RACETAB AND FINISHLYNX"I have Racetab and Finishlynx talking to each other and the files are being written to the Timing Sessions folder. I have the FAT camera set to automatic but no times show up after evaluating the race in Finishlynx and saving. In Racetab if I right…"
Profile Information
- How do you use RaceTab?
- XC andTrack
© 2019 Created by Jason Byrne.
Powered by
