I am trying to pull track times from my timing computer (A) into a separate results computer (B) using racetab.  I have them networked.  I can see the folder that I want to pull results from on computer B,  but I can't get racetab to have preferences changed.  I am stuck at default location and get one of those bad messages. Basically- how do I reset location from default to the new networked folder

Views: 209

Reply to This

Replies to This Discussion

In RaceTab you should setup a source (FAT Camera) and set the data folder in Source properties to the folder where the timing Computer (A) is saving the results. On the network make sure that folder is shared so you can get to it from the RaceTab computer (B).  This will get results into RaceTab from the Source, i.e.; Sync to Source (Get Times)

Reply to Discussion


Facebook Page

© 2020   Created by Jason Byrne.   Powered by

Badges  |  Report an Issue  |  Terms of Service